How can I enable the missing parameters or fine tune the interface with the new iflib tried already, but I tried with your module also: kldstatģ 1 0xffffffff83adf000 58f30 if_ix_updated.ko How can I enable or fine tune the interface with the new iflib driver? The issue now is if I go with the driver included I got very low speeds ~150 Mbs/s, and I can't tune the interface because some parameters are missing: sysctl hw.ix on 12.0-RELEASE:Īlso I found this issue with the same chipset: Please go through my discussions with Intel and FreeBSD if you have time, and if you can, help me in order to solve this. I didnt want to post a question before I tried to gather all the information I could. Rather than a modules/ixgbe there is now modules/ix and modules/ixv The driver loadables will now match the device names, something that What I like to point out is, on pfSense 2.4.5 or 2.4.4 Netmap was running on Native mode, so it's not a hardware issue.Īlso please note that ixgbe driver changes names depending on devices names as quoted in my discussion with FreeBSD guys: Log Message: I understood that NETMAP is disabled on FreeBSD 12.1, as someone kindly provided this line: MAX_NETMAP_OSVERSION= 1199999 # Doesn't build w/NETMAP on 12Īlso I requested help from Intel also here:īasically they've told me to not use FreeBSD 12.1 :) Ix3: permanently promiscuous mode enabledĢ52.245959 generic_netmap_attach Emulated adapter for ix3 created (prev was NULL)Ģ52.498624 generic_netmap_register Emulated adapter for ix3 activatedĪfter some discussions on FreeBSD forums here: ix3: link state changed to UPĢ52.220553 generic_netmap_attach Emulated adapter for ix3 created (prev was NULL)Ģ52.220605 generic_netmap_dtor Emulated netmap adapter for ix3 destroyed Page Sizes: 4096 (enabled), 8192, 65536, 262144, 1048576, 4194304Īfter compiling NETMAP will start only in Emulation mode, hence I will get a very high speed penalty, of only ~150 Mbs/s in comparison with Linux or FreeBSD 11.3 where it worked. Link x1(x1) speed 2.5(2.5) ASPM L0s/L1(L0s/L1)Įcap 0001 = AER 2 0 fatal 0 non-fatal 1 correctedĮcap 0003 = Serial 1 0100c9ffff000000Įcap 0010 = SR-IOV 1 IOV disabled, Memory Space disabled, ARI disabledįirst VF RID Offset 0x0080, VF RID Stride 0x0002 Table in map 0x20, PBA in map 0x20Ĭap 10 = PCI-Express 2 endpoint max data 128(128) FLR RO Pciconf -lvc output: class=0x020000 card=0x00008086 chip=0x15e58086 rev=0x11 hdr=0x00Ĭap 01 = powerspec 3 supports D0 D3 current D0Ĭap 05 = MSI supports 1 message, 64 bit, vector masksĬap 11 = MSI-X supports 64 messages, enabled The driver for FreeBSD as far as I know is this:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |